What is the bearing and its structural classification Bearing is an important part of modern mechanical equipment. Its main function is to support the mechanical rotating body, reduce the frict...
Clutch principle and working process Principle For vehicles with manual transmission, the clutch is an important part of the vehicle power system, which is responsible for cutting off and connecting t...
What are the causes of clutch slip and how to eliminate them The causes and troubleshooting of clutch slipping are as follows: Phenomenon: When the car starts, completely release the clutch pedal, and...
Working Principle of Remote Radiator Cooling If the geneset is installed below the plane, due to the space limitation, it is recommended to use the remote radiator to cool the engineing. In the ...
Air Quality and Temperature Influence on Generator If the generator is used indoors, we must ensure that it has enough fresh air. If the engine room is sealed too tightly, it will lead to poor air cir...
Difference between scraper, loader, bulldozer and excavator Loaders usually appear in seaports and logistics centers and are mainly used for loading and unloading containers. The grader is used to sho...
Cummins generator sensor type Sensors are classified as temperature, oil pressure, combined type, speed and position sensors 1.Coolant temperature sensor The sensor is located on the front righ...
What are the differences and connections between transmitters and sensors? Sensor is the general name of devices or devices that can be measured and converted into usable output signals according to c...
Structure and working principle of automobile ignition coil With the development of automobile gasoline engine in the direction of high speed, high compression ratio, high power, low fuel consumption ...
Classification and Features of electronic governor 1.Analog electronic governor: its controller is usually assembled with analog electronic components; 2.Digital electronic governor: its contro...
The difference between electronic governor and frequency governor on motor speed regulation First, the speed regulation of the electronic governor is usually carried out by a single-phase motor...
Camshaft Introduction The camshaft is a component of a piston engine. Its function is to control the opening and closing of the valve. Although the speed of the camshaft in a four-stroke engine is hal...
