Poor heat dissipation performance of radiator The radiator is the cooling device of the cooling system. It should be ensured that there is enough heat dissipation area against the wind. After the engi...
Maintenance Points Of Pulley Radiator 1.During disassembly and assembly, pay special attention to water leakage caused by collision. The installation position must meet the requirements of the origina...
All different types of belts in a typical engine The belt is a simple component, but it plays an important role in the operation of the engine. In short, the belt provides power for a component...
Why choose a belt drive over a chain drive? The function of belt drive and chain drive is very similar. However, what are the advantages of belt drive over chain drive? Reduce maintenance requi...
Cause analysis of cylinder sleeve wear The working environment of cylinder liner is very bad, and there are many reasons for wear. Under normal circumstances, due to construction reasons, normal wear ...
Type of common cylinder gasket Common cylinder gaskets include asbestos (non asbestos) rubber composite gasket, metal clad (copper clad iron clad) gasket, composite coating gasket, metal composite gas...
What should be paid attention to when the tractor changes speed? (1)When shifting, the clutch pedal should be pressed to the bottom, so that the clutch can be completely separated before shifting, so ...
Causes and solutions of low engine oil pressure Reasons for low engine oil pressure: Oil pump wear, pressure limiting valve wear or foreign matters; Low oil storage; Oil or viscous for a long time dur...
What is the reason for unstable engine speed? What about the solution? Usually, this is caused by the leakage of the intake system and valves, excessive scaling of the throttle valve and intake pipe, ...
What are the common faults of automobile brake system? 1.Fault phenomenon: the pedal does not rise when the brake pedal is pressed, and there is no resistance; Judge the reason: check whether the brak...
Causes of diesel engine starting difficulty From the working principle of the engine, it can be seen that the fuel system should regularly and quantitatively inject fuel into the cylinder, and ensure ...
What is the reason for the insufficient power of the diesel engine? How to solve it? 1.Faulty injector Injector faults are generally divided into mechanical faults and wiring faults. Mechanical...
