What safety technical items should be checked before the tractor is delivered? (1)The engine has good starting performance, stable idle speed, smooth acceleration, no abnormal noise, no oil leakage, w...
What are the common faults of the tractor rear axle and steering system? Common faults of rear axle: abnormal noise of transmission; Rear axle oil leakage; Steering clutch slipping; Eccentric wear of ...
Causes and solutions of low engine oil pressure Reasons for low engine oil pressure: Oil pump wear, pressure limiting valve wear or foreign matters; Low oil storage; Oil or viscous for a long time dur...
What are the common faults of automobile brake system? 1.Fault phenomenon: the pedal does not rise when the brake pedal is pressed, and there is no resistance; Judge the reason: check whether the brak...
What is the bearing and its structural classification Bearing is an important part of modern mechanical equipment. Its main function is to support the mechanical rotating body, reduce the frict...
Clutch principle and working process Principle For vehicles with manual transmission, the clutch is an important part of the vehicle power system, which is responsible for cutting off and connecting t...
What are the causes of clutch slip and how to eliminate them The causes and troubleshooting of clutch slipping are as follows: Phenomenon: When the car starts, completely release the clutch pedal, and...
Working Principle of Remote Radiator Cooling If the geneset is installed below the plane, due to the space limitation, it is recommended to use the remote radiator to cool the engineing. In the ...
Air Quality and Temperature Influence on Generator If the generator is used indoors, we must ensure that it has enough fresh air. If the engine room is sealed too tightly, it will lead to poor air cir...
Water Cooling Principle Of The Diesel Generator The cooling water jacket is cast in the cylinder head and cylinder block of the diesel engine. After being pressurized by the water pump, the coolant en...
Difference between scraper, loader, bulldozer and excavator Loaders usually appear in seaports and logistics centers and are mainly used for loading and unloading containers. The grader is used to sho...
What are the differences and connections between transmitters and sensors? Sensor is the general name of devices or devices that can be measured and converted into usable output signals according to c...
